Don’t freak out if your LG washing machine’s LCD suddenly flashes the original equipment manufacturer trouble code. One of the most frequent problems with LG washers, this one is typically simple to resolve. This thorough guide, which is specifically designed for LG owners in the USA, will explain what the LG washer OE code means, its typical causes, and how to fix it step-by-step.
🔍 What Does the OE Code for LG Washers Mean?
On LG washing machines, the “OE” error code denotes “Drain Error.” It shows that the water cannot be drained by the washer in the anticipated amount of time. This can occur for a number of reasons, including a malfunctioning drain pump, a kinked hose, or a blocked drain pump filter.
Typical Reasons for the OE Error Code
Let’s examine the most common causes of your LG washer displaying the original equipment manufacturer code:
Blockage in the Drain Pump Filter
Debris such as fabric fibers, coins, and lint can clog the filter and prevent water from draining.
Drain hose that is kinked or blocked
Water cannot properly depart the machine if the drain hose is damaged or obstructed.
A malfunctioning drain pump
The pump motor may deteriorate or wear out over time.
Poor Drain Height or Installation
Drainage problems may arise if the drain pipe on your washer is positioned too high or too low.
Unexpected Power Outage or Error
Occasionally, a power spike or malfunction may cause the washer’s electronics to become confused and display erroneous diagnostic codes.
How to Correct the OE Code on LG Washers Step-by-Step
Here is a simple way to troubleshooting and resolving the issue:
✅ First, turn off the washer.
For safety, unplug the washer from the power source. To reset any internal electronics, let it sit for at least ten to fifteen minutes.
Examine and clean the drain pump filter in step two.
Find the filter access panel on the washer’s front bottom.
To capture water, use a towel and a shallow container underneath.
Slowly detach the drain filter after opening the panel.
Clear away any fabric fragments, hairpins, coins, or lint.
After rinsing the filter under running water, replace it with a tight screw.
💡 Pro Tip: To prevent more OE problems, clean the drain filter every one to two months.
Examine the drain hose in step three.
The washer should be pulled away from the wall.
Look for bends or obstructions along the drain hose’s whole length.
Disconnect the hose and run water through it using a faucet or hosepipe.
For adequate drainage, make sure the drain height is between 24 and 36 inches off the floor and reattach it securely.
Step 4: Execute a Drain or Spin Cycle
To check if the problem has been fixed, plug the washer back in and do a spin-only or drain cycle.
The issue will be resolved if the washer drains properly.
Proceed to the following step if the OE code persists.
Step 5: Examine the drain pump and replace it if necessary.
The drain pump motor might be the problem if clearing the filter and hose didn’t resolve it.
While the drain cycle is going on, listen for a humming noise. The motor may be broken if it is silent.
The drain pump will probably need to be replaced.
You have two options:
Employ a technician certified by LG, or
If you are familiar with appliances, purchase a replacement pump online for about $25 to $60 and do it yourself.
⚠️ Caution: Disassembling the washer is necessary to replace the pump. Only proceed if you are certain, or get in touch with LG Support.
🧼 Stopping Upcoming OE Error Codes
The following advice will help you prevent OE errors in the future:
Regularly clean the drain filter.
Don’t put too much strain on the washer.
Only use high-efficiency (HE) detergent.
Refrain from cleaning extremely dirty goods without first shaking off any particles.
Every few months, check and clean the drain hose.
📞 When to Contact LG Customer Support
After completing the aforementioned procedures, if the OE code still appears, there may be a more serious problem with the control board or internal wiring. It’s recommended to get in touch with LG USA customer service at this time or arrange for an in-home repair.
USA: https://www.lg.com/us/support LG Support
Telephone for Customer Service: 1-800-243-0000
🛍️ Accessories and Replacement Parts (USA Shoppers)
If you want to purchase cleaning supplies or replacement components for your LG washer in the United States, take a look at:
The Official LG Store in the USA
The Home Depot
Lowe’s
US Amazon
Look for:
“LG Drain Pump for Washers”
“Replacement of LG Drain Hose”
“Tablets for Washing Machine Cleaners”
Concluding remarks
Although the LG washer OE code may appear frightening, it is typically a straightforward drainage problem that can be resolved in less than an hour. Most homeowners can fix this without hiring an expert, from cleaning the drain filter to inspecting the hose and pump.
By keeping up with regular maintenance and following recommended practices, you’ll not only avoid the OE error but also extend the life of your LG washer.